|
01.
Space-saving, the structure light of efficient heat exchange
cooling tower designed specifically for this series filler,
the substantial increase of the heat transfer area, the
original the HBLD series and original HBLCD of series
compared, which covers an area dropped significantly, due to
the optimization of the structural design and the use of
steel, running weight is also greatly reduced.
02. Cross-flow FRP cooling tower save electricity using
small ventilation resistance filler designed for cooling
tower designed by Tsinghua University wing FRP efficient
fans, thereby reducing the power of the motor is equipped
with ultra-low-noise type with a smaller motor power, save
more electricity cross-flow FRP cooling tower can also be
based on the user's requirements, is equipped with two-speed
motor to save power.
03. The very low of running noise Tsinghua University,
designed specifically for cooling tower FRP material wing
low noise axial fans and cooling tower design of low-noise
motor , which reduce running noise of the cooling tower.
Lower noise, ultra-low noise series cooling tower operation
in full compliance with the requirements of environmental
protection. Equipped with a two-speed motor, when the night
low speed, but also the noise further decreased by 2-3dB
(A), the user needs a two-speed motor should be in a
separate request when ordering.
04. Good corrosion resistance cross-flow FRP cooling tower
tower body, sink and panel are used has good corrosion
resistance FRP material, gel coat resin plus light
stabilizers, has a good anti-aging properties, prolonged
does not change color. Tower body steel pieces after
processing using the galvanizing treatment, to improve the
corrosion resistance of the cooling tower, within the normal
service life, without additional preservative. The
05. Combinations convenience can use a combination of ways
to meet the requirements of different working conditions,
the combination can also be determined based on site
conditions, and in accordance with the characteristics of
buildings, adjustment cross flow FRP cooling tower
appearance. Such as the user's premises are very limited. I
also designed for the special requirements of the user, to
meet the user requirements of thermal performance and noise.
06. Maintenance a convenient in this series cooling tower as
modular design, the the neighboring cooling tower air
chamber spaced apart from each other, in the normal
operation of the premise of the cooling tower, maintenance
and overhaul, work more convenient, stagnant water pipe and
tank cleaning filler. |
